Titre:	Influence of parameter variation and interlayer temperature control in wall angle, curvature and measurement methodology of er70s-6 parts obtained by waam
Auteur(s):	Vieira, Ruan Diego Amorim de Melo Liskevych, Olga Oliveira, Déborah de Ziberov, Maksym
metadata.dc.identifier.orcid:	https://orcid.org/0009-0008-3455-0808 https://orcid.org/0009-0003-5739-0433 https://orcid.org/0000-0002-7340-5792 https://orcid.org/0000-0001-6620-8806
metadata.dc.contributor.affiliation:	University of Brasilia, Mechanical Engineering Department Federal University of Espirito Santo, Technological Center, Mechanical Engineering Department University of Brasilia, Mechanical Engineering Department University of Brasilia, Mechanical Engineering Department
Assunto::	Manufatura aditiva por arco elétrico e arame (WAAM) Controle de temperatura entre camadas Aço ER70S-6 Parâmetros de processo Ângulo de parede
Date de publication:	nov-2024
Editeur:	Elsevier BV
Référence bibliographique:	VIEIRA, Ruan Diego Amorim de Melo; LISKEVYCH, Olga; OLIVEIRA, Déborah de; ZIBEROV, Maksym. Influence of parameter variation and interlayer temperature control in wall angle, curvature and measurement methodology of er70s-6 parts obtained by waam. Manufacturing Letters, [S. l.], v. 42, p. 40-45, 2024. DOI: https://doi.org/10.1016/j.mfglet.2024.10.006. Disponível em: https://www.sciencedirect.com/science/article/pii/S2213846324003225?via%3Dihub.
Abstract:	Wire and Arc Additive Manufacturing is characterized for the high deposition rates, enabling the manufacturing of big, complex parts, with smaller relative production cost. However, once the part receives high heat inputs, leading to geometry variation and deformations, it is important to properly measure the part characteristics. Therefore, this work contributes with a measurement methodology for inclined walls deposited by Wire and Arc Additive Manufacturing and its application on walls deposited with different parameters. The main parameter of influence was the use of interlayer temperature control, which increased the angle in 71.0%, and the curvature in 90.3%, lower part.
metadata.dc.description.unidade:	Faculdade de Tecnologia (FT) Departamento de Engenharia Mecânica (FT ENM)
DOI:	https://doi.org/10.1016/j.mfglet.2024.10.006
metadata.dc.relation.publisherversion:	https://www.sciencedirect.com/science/article/pii/S2213846324003225?via%3Dihub
Collection(s) :	Artigos publicados em periódicos e afins

Tous les documents dans DSpace sont protégés par copyright, avec tous droits réservés.